Difference between revisions of "EN/documentation/ooo3 user guides/getting started/getting started with macros"

From Wiki
Jump to navigationJump to search
m (1 revision)
 
Line 1: Line 1:
{{DISPLAYTITLE:Getting Started with Macros}}
+
<section begin=title /><noinclude>{{DISPLAYTITLE:</noinclude>Getting Started with Macros<noinclude>}}</noinclude><section end=title />
 +
 
 
{{Documentation/GS3MacroTOC
 
{{Documentation/GS3MacroTOC
 
|ShowPrevNext=block
 
|ShowPrevNext=block

Revision as of 07:28, 6 April 2012



This is Chapter 13 of Getting Started with OpenOffice.org 3.x, produced by the OOoAuthors group. A PDF of this chapter is available from this wiki page.


Your first macro

A macro is a saved sequence of commands or keystrokes that are stored for later use. An example of a simple macro is one that “types" your address. The OpenOffice.org macro language is very flexible, allowing automation of both simple and complex tasks. Macros are especially useful to repeat a task the same way over and over again.

OpenOffice.org macros are usually written in a language called StarBasic, or just abbreviated Basic. Although you can learn Basic and write macros, there is a steep learning curve to writing macros from scratch. The usual method for a beginner is to use the built-in macro recorder, which records your keystrokes and saves them for use.

Most tasks in OpenOffice.org are accomplished by “dispatching a command" (sending a command), which is intercepted and used. The macro recorder works by recording the commands that are dispatched (see The dispatch framework).

Error in widget AddThis: Unable to load template 'wiki:AddThis'
Content on this page is licensed under the Creative Common Attribution 3.0 license (CC-BY).