Chapter 13. Getting Started with Macros

From Wiki
Revision as of 11:00, 9 April 2012 by Sancho (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search



This is Chapter 13 of Getting Started with OpenOffice.org 3.x, produced by the OOoAuthors group. A PDF of this chapter is available from [[EN/documentation/ooo3_user_guides/chapters|EN/documentation/ooo3 user guides/chapters]].


Your first macro

A macro is a saved sequence of commands or keystrokes that are stored for later use. An example of a simple macro is one that “types" your address. The OpenOffice.org macro language is very flexible, allowing automation of both simple and complex tasks. Macros are especially useful to repeat a task the same way over and over again.

OpenOffice.org macros are usually written in a language called StarBasic, or just abbreviated Basic. Although you can learn Basic and write macros, there is a steep learning curve to writing macros from scratch. The usual method for a beginner is to use the built-in macro recorder, which records your keystrokes and saves them for use.

Most tasks in OpenOffice.org are accomplished by “dispatching a command" (sending a command), which is intercepted and used. The macro recorder works by recording the commands that are dispatched (see Sometimes the macro recorder fails/The dispatch framework).


Content on this page is licensed under the Creative Common Attribution 3.0 license (CC-BY).